EC390 cable assembly
- High-quality, reliable cable assembly for CA134 and CA280 vibration systems
- K341 cable with RADOX® insulation (Ø4.5 mm)
- Threaded connector (CG134) to flying leads
- 2-wire, with shield
Description
High-quality, high-reliability cable assembly for use with the CA134 and CA280 vibration sensors (accelerometers using external signal conditioners).
For use in harsh environments characterised by high temperatures and/or hazardous areas (potentially explosive atmospheres).
Features
- High-quality, reliable cable assembly for CA134 and CA280 vibration systems
- K341 cable with RADOX® insulation (Ø4.5 mm)
- Threaded connector (CG134) to flying leads
- 2-wire, with shield
The following downloads are available for this product:
Related products
-
-
- LS120 air-gap sensor
- Designed for the contactless measurement of the air-gap between rotor and stator in hydroelectric generators, and large alternators and motors
- 5 to 30 mm linear measurement range (1.875 to 33.125 mm)
- −15 to 125 °C operating temperature
- Withstands magnetic fields up to 1.5 tesla
- Integral cable length of 5 or 10 m
-
-
-
- AE119 housing expansion probe
- Designed for the long-term measurement of housing expansion in extreme environments, such as gas turbines and steam turbines
- 50 or 100 mm measurement range
- 0 to 80 °C (32 to 176 °F) operating temperature, IP54 protection rating
- Integrated electronics
- Current loop output (4 to 20 mA) for signal transmission over long distances
-
-
-
- CP211 piezoelectric pressure transducer
- Designed for the long-term measurement of pressure pulsation in extreme environments, such as gas turbine combustors
- Very high operating temperature: up to 650 °C (1202 °F)
- Very high frequency response: up to 15000 Hz
- Available in different integral mineral-insulated (MI) cable lengths, terminated with either a high-temperature connector or a LEMO connector
- Certified for use in potentially explosive atmospheres
-
-
-
- PA151 probe mounting adaptor
- Removable probe housing and probe adaptor rod to support the external mounting of a TQ912 proximity sensor
- Sealed die-cast polyester housing and stainless steel adaptor rod
- Easier probe installation and gap adjustment with adaptor rod lengths from 50 to 800 mm (mounting position adjustable to ±10 mm)
- −40 to 100 °C temperature, IP65 protection rating
- Certified for use in potentially explosive atmospheres
-