Related products

• 

  • 
  • Capacitive-coupling adaptor for VM600 IOC4T card
  • • 4 individually configurable channels for use with IOC4T buffered (raw) transducer outputs
    • AC couples a channel’s buffered (raw) transducer output signal and removes the DC component
    • 1 μF series capacitor or straight-through connection per channel
    • Reduces external circuitry and wiring when the buffered (raw) transducer outputs of an IOC4T card are connected to test and measurement equipment
  Compare
• 

  • Out of Stock
    
  • VM600 CPUR rack controller and communications interface card

  • These cards are discontinued with some spares available.
    – VM600: no replacement.
    – VM600Mk2: replaced by CPUMMk2 + IOCNMk2 with redundancy (via firmware upgrade) available 2024.

    • VM600 CPUR/IOCR rack controller and communications interface card pair with support for Modbus RTU/TCP and card pair redundancy
    • “One-Shot” configuration management of protection cards (MPC4 and AMC8) in a VM600 rack using an Ethernet connection to a computer running the VM600 MPSx and VibroSight® software
    • Rack controller and communications redundancy with two CPUR/IOCR card pairs: Master (active) and Inactive (redundant)
    • Five output relays to signal system statuses and alarms
    • VM600 system event and measurement event logs available via VibroSight® software
  Compare
• 

  • 
  • VM600 XIO16T input/output module for XMx16 modules

  • These cards are still available with phase out planned for 2025.
    – VM600Mk2: replaced by VM600Mk2 XMx16 + XIO16T.

    Note: VM600 and VM600Mk2 versions of the XMx16 + XIO16T are the same, except for different Mk2 branding cards.

    • Input/output (interface) module for the XMV16 and XMC16 modules – supporting 16 dynamic channels and 4 tachometer channels
    • Differential signal input per dynamic channel and tachometer channel
    • Designed for operation with the VibroSight® software: one Ethernet connector (8P8C (RJ45)) for communication with VibroSight
  Compare
• 

  • Out of Stock
    
  • VM600 RLC16 relay card

  • This card is being phased out with spares available until 2027.
    – VM600: no replacement.
    – VM600Mk2: replaced by RLC16Mk2.

    • Additional relays, driven by MPC4 and/or AMC8 card signals for when the 4 relays on the IOC4T and IOC8T cards are not enough
    • 16 SPDT relays
    • Hardware configurable
    • Relays configurable as normally energised (NE) or normally de-energised (NDE)
    • All relay contacts are available on the screw-terminal connectors
  Compare