Description
Rack power supplies for VM600Mk2
Key features
- AC-input version (115/230 VAC or 220 VDC) and DC-input versions (24 VDC and 110 VDC)
- High-power, high-performance, high-efficiency design with status indicator LEDs (IN, +5V, +12V and −12V)
- Over-voltage, short-circuit and overload protection
- One RPS6U rack power supply powers a full rack of modules (cards)
- Two RPS6U rack power supplies enable rack power supply redundancy
Additional information
| Monitoring system (application) | Machinery protection, condition monitoring, combustion monitoring |
|---|---|
| VM600 system function | Common |
| VM600 system component | Rack power supply |
| VM600 component function | Power supply |
| VM600 component and rack compatibility | ABE040, ABE042 |
The following downloads are available for this product:
Related products
-
-
- VM600 XMC16 condition monitoring module for combustion
These cards are still available with phase out planned for 2025.
– VM600Mk2: replaced by VM600Mk2 XMx16 + XIO16T.Note: VM600 and VM600Mk2 versions of the XMx16 + XIO16T are the same, except for different Mk2 branding cards.
- 16 dynamic channels and 4 tachometer channels
- Up to 20 processed outputs per dynamic channel and per dual-channel (12 per XMC16)
- Simultaneous data acquisition on all channels with asynchronous (fixed frequency) or synchronous (order tracked) sampling
- 24-bit data acquisition, high SNR data processing, with a high-resolution FFT up to 6400 lines every 500 ms
- Designed for operation with the VibroSight® software
-
-
- Out of Stock
- VM600 IOCN input/output card for CPUM card
These cards are discontinued with spares no longer available, please see below for an updated alternative.
– VM600: replaced by CPUR2 and IOCR2.
– VM600Mk2: replaced by CPUMMk2 + IOCNMk2.- Input/output (interface) card for CPUM card
- One primary Ethernet connector (8P8C (RJ45)) for communication with the VM600 MPSx software and/or Modbus TCP and/or PROFINET communications
- One secondary Ethernet connector (8P8C (RJ45)) for redundant Modbus TCP communications
- One primary serial connector (6P6C (RJ11/RJ25)) for communication with the VM600 MPSx software via a direct connection
- Two pairs of serial connectors (6P6C (RJ11/RJ25)) that can be used to configure multi-drop RS-485 networks of VM600 racks
-
-
-
- VM600 CPUR2 rack controller and communications interface card
- VM600 CPUR2/IOCR2 rack controller and communications interface card pair with support for Modbus TCP and PROFIBUS DP
- “One-Shot” configuration management of protection cards (MPC4) in a VM600 rack using an Ethernet connection to a computer running the VM600 MPSx and VibroSight® software
- Mathematical processing of data to be shared via fieldbus and card pair status (health) information via fieldbus
- Common alarm reset (AR) for protection cards and VM600 MPS rack (CPUR2) security with a removable key
- Two output relays to signal system statuses and alarms
-
-
-
- Capacitive-coupling adaptor for VM600 IOC4T card
- 4 individually configurable channels for use with IOC4T buffered (raw) transducer outputs
- AC couples a channel’s buffered (raw) transducer output signal and removes the DC component
- 1 μF series capacitor or straight-through connection per channel
- Reduces external circuitry and wiring when the buffered (raw) transducer outputs of an IOC4T card are connected to test and measurement equipment
-